![]() Manually associate the device with the appropriate driver.Then, restart the computer and let the device's software install automatically. Right-click on the device and uninstall it in Device Manager.If your device appears under a different category, complete one or both of the following procedures:.If your device appears under Data Acquisition Devices, verify the NI Device Loader service is started.If your device or module does appear in Windows Device Manager, check under what category it appears.If you are using an NI USB DAQ device, also review the section below. You can find the voltage ratings in the specification sheets for you computer and the DAQ card. If it does not, make sure that the device is plugged in correctly, and check for any loose connections. Also make sure that the PCI bus on your computer has the same Voltage rating as the DAQ card you are using. Check to see whether your DAQ device appears in Windows Device Manager.With NI MAX open, start by refreshing the list of connected devices by clicking View»Refresh.You will then to need restart your system. If you recently installed to a newer version of LabVIEW, try repairing the DAQmx driver.If you have recently installed new NI software, drivers, or hardware, restart your operating system (OS).If you do not have all three of these, please reinstall DAQmx. Note: Your driver may not be version 18.1. You should see the following three under the Software drop-down in NI-MAX: You can check this in NI MAX by expanding My System » Software. MAX Configuration allows you to configure the devices within NI MAX. Device Driver has the drivers for the different DAQ devices. ADE Support allows DAQmx to interface with LabVIEW. The DAQmx driver incompasses 3 parts, ADE Support, Device Driver, and MAX Configuration. Ensure that you have the correct DAQmx driver software.You can find most NI-DAQmx readme’s on the NI-DAQmx Release Notes Page. Check to see if the correct drivers are installed for your DAQ hardware by checking the readme for that version of NI-DAQmx. Confirm that you have DAQmx installed and determine the version of NI-DAQmx already installed on your system. Note that some devices and modules are no longer supported in NI-DAQmx 17.6 and later. Swap power supplies, try different slots, power cycle the device, and reset the system.Confirm your device is powered on and connected to your computer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |